1
Channel Potentiometer Out (OWPOT1)
Description:
This 1-wire card uses the DS2890
IC which has one programmable linear taper potentiometer which
supports voltages up to 11 volts. You may use this module to
generate output (D-A) control voltages.
Card Type: 129
Connector CN2
(5-pin style) Pinout
Pin
Numbers |
Description |
1 |
Common |
2 |
Potentiometer
Common (Must connect pin 2 to pin 1) |
3 |
Potentiometer
wiper |
4 |
Potentiometer
High (can connect pin 4 to pin 5 or connect to any voltage
up to 11 V with respect to Common) |
5 |
+5V Power Output |
Connector CN2
(6-pin style) Pinout:
Pin
Numbers |
Description |
1 |
Common |
2 |
No Connection |
3 |
Potentiometer
High (can connect pin 3 to pin 6 or connect to any voltage
up to 11 V with respect to Common) |
4 |
Potentiometer
wiper |
5 |
Potentiometer
Common (Must connect pin 5 to pin 1) |
6 |
+5V
Power Output |
OWconfig:
The "Type" must be 129 as described
above. The "Mode" must always be "Separate power".
Modbus Register
Information:
This device has one Modbus output
register on the ICONIO board used to set the potentiometer wiper
position. The register value range is 0 to 255.
Specifications:
Parameter |
Specification |
Temperature |
-40 to +85C (-40 to +185F) |
Potentiometer
Low |
Must be tied to Common |
Potentiometer
High |
Up to 11V with respect to
Common. Can also connect to +5V power output. |
Register Range |
0 to 255 (Sets the wiper
in 256 steps) |
Resistance
Value |
100K ohms |
Resistance
Tolerance |
+/-25% |
Schematic
and Parts List:
Reference |
Part Number |
CN1 |
Digikey 281-1451-ND |
CN2 |
Digikey 281-1452-ND |
D1 |
Dallas Semi DS9503P |
D2, D4 |
Digikey SA5V0ADICT-ND |
U1 |
Dallas Semi DS2890P-000 |
|